<big id="h39ph"><meter id="h39ph"><menuitem id="h39ph"></menuitem></meter></big> <big id="h39ph"><meter id="h39ph"><meter id="h39ph"></meter></meter></big><progress id="h39ph"><meter id="h39ph"></meter></progress><meter id="h39ph"><mark id="h39ph"></mark></meter><big id="h39ph"></big> <big id="h39ph"><menuitem id="h39ph"></menuitem></big><progress id="h39ph"><menuitem id="h39ph"></menuitem></progress><big id="h39ph"><menuitem id="h39ph"></menuitem></big><big id="h39ph"><progress id="h39ph"><menuitem id="h39ph"></menuitem></progress></big>
Kaabo si wa w??bù!

?ja

NIPA RE

IFIHAN ILE IBI ISE

DML Plastic m Co., Limited, ti i?eto ni 2001, ni a asiwaju ab?r? igbáti i?oogun ni China.

DML m am?ja ni ?i?u m gbóògì fun ìdílé onkan, egbogi aw?n ?r?, itanna aw?n ?r?, ailewu aw?n ?r? bi daradara bi monitoring eto.

Aw?n ile-ni o ni lori 50000 square mita factory. P?lu ?i?u ab?r? tooling ìpín possessing o yat? ?r? ati ?rìr?, DML m nfun irin?? lati kekere ati kong? foonu alagbeka aw?n ?ya to bi ńlá bi Oko aw?n ?ya ara.?

Aw?n iroyin

DML ?i?u m Co., Ltd

DML m am?ja ni ?i?u m gbóògì fun ìdílé onkan, egbogi aw?n ?r?, itanna aw?n ?r?, ailewu aw?n ?r? bi daradara bi monitoring eto.

Draft angle injection molding What is the draft angle? The?draft angle is the amount of taper for?molded?or?cast?parts perpendicular to the parting line. It can be measured in?degrees?or mm/m...
For the injection parts surface finish, DML manages with three ways done on mold: Polishing surface, EDM surface and Texture surface. 1.For the polishing surface: It is relatively simple,?...
WhatsApp Online Awo!
手机真钱的棋牌游戏